air inlet

The control end of the two-position five-way valve ( 8) is connected with a compressed air inlet pipe through a switch ( 11).

两位五通阀（8）的控制端通过开关（11）与压缩气进气管连接。

Sugar cane solution is used as a trial solution in experiment. An evaporative capacity of impinging-stream concentrator is studied by changing inlet air temperature, and the ratio of inlet sugar solution flow rate to inlet gas flow rate and the length of accelerating pipe.

采用蔗糖水溶液作为试验溶液，通过改变空气进口温度、液气质量流量之比、液滴加速管的长度等对撞击流浓缩器（ISC）的蒸发能力进行了研究。

Instrumentation of Air Inlet Resistance for Engines of Military Vehicle

军用车辆发动机进气阻力测试仪

The mixing degree and gasoline-air distribution performance when air is introduced through the radial inlet are between that of tangential air flow and axial air flow, and the system energy loss is the largest.

而径向进气的油气分布、混合程度介于切向与轴向进气之间，能耗较大。

Otherwise, the air exhauster is not necessary, and the air inlet ( 4) connecting with the high-pressure clean air is arranged in the air inlet pipeline.

或不用抽气机，而在进气管道有一接高压清洁空气的进气口（4）。

The two ends of the drying chamber are arranged with an air inlet channel and an air outlet channel;

所述干燥室两端设有进气通道和排气通道；

As the air inlet diameters increase, the intake central swirl is intensified and thus fuel evaporation in the first combustion chamber is improved.

加大进气孔直径使进气中心涡流增强，燃油在一级燃烧室中蒸发量增加。

Separation of the water supply from the air inlet is accomplished by means a diaphragm seal.

水供应与空气进口的分离通过隔膜密封的方法实现.

Let's make the little air inlet under the front panels.

让我们使小进风口下阵线面板.

Remove the air inlet hose from the throttle body and air cleaner.

从节流阀体和空气滤清器上拆下气流入口软管.

When the bulb is compressed, an air inlet valve prevents blow back from the nozzle.

带有、无压缩的切换功能.带防止从吹出口吸入灰尘(逆流)功能.

The air admission grill, lower part undergoes the redesign, increased the strength full auxiliary air inlet.

进气格栅, 下部经过重新设计, 增加了力道十足的辅助进气口.

Through lowering the air inlet total pressure, reducing the compression angle of air, increasing the nozzle length, cutting down the nozzle radius and the axial gap of electrode, the arc ignition energy can be improved.

通过减小流动压差、缩小空气压缩角、增加喷孔长度、减小喷孔半径以及减小轴向间隙等可以有效提高电弧的点火能量。

The utility model relates to a pneumatic injection pump, comprising a cover board, a vessel, an air inlet, compressed air, mortar and a grout outlet.

气压式注浆泵主要由盖板、容器、进气口、压缩空气、砂浆和出浆口组成。

The air inlet distributor is a biconical diversion type.

进气分布器为双锥导流式.

A housing includes an air inlet , an air outlet and an airflow path there through.

外壳包括空气入口 、 空气出口和空气气流通路.

A cover , including an air cowl , is removably mounted to the housing proximate the air inlet.

外罩, 包括空气通风帽, 被可拆卸地安装在外壳的靠近空气入口处.

The simulation results of inlet air manifold show that the uniformity of the velocity at outlet of the manifold are improved by using the appropriate bell-mouthed inlet and clipper-built baffle, and inlet pressure needed of the manifold decrease.

对进气箱的模拟结果表明，采用扩压型进口加流线型挡块的方案可以提高出口速度的均匀性，同时降低了进气箱入口所需的气体压力。

Turn off supply pressure and observe float drop to open air inlet.

关闭供应压力,观察浮子下降,因此开启空气进口.

Air inlet has effects on complete carry up, but tube diameter no effects on that, the smaller of diameter, the larger of or J_g in complete carry up.

气体入口条件对全部携带点无影响，但管径对全部携带点有影响，管径越小全部携带点所对应的J8值越大。

In comparison with 30 ° air inlet, the generated vortexes are fewer, weaker and nearer to the air inlets when the inlet angle is 45 ° along the axial cross section.

与30°进气道相比，沿轴向横截面上45°进气道所形成的回流区向进气道一侧偏移，回流区区域减少，强度减弱。

Poor sealing effects of temperature probe of scroll of bearing box at air inlet side of the air compressor results in oil contamination of following pipeline of air compressor.

由于空压机进气侧轴承箱蜗壳温度探头密封效果不好，使空压机及其后续管道受到油污染。

In the meantime , the effect of air inlet angle on particle deposition was also researched.

同时, 研究了不同气流进口角对粒子沉积状况的影响.

3-D flow field analysis and numerical simulation in fuel cell air inlet manifold

燃料电池气体分配箱三维流场分析与数值模拟

Slowly open vent needle valve just as air inlet opens. Record differential pressure.

当空气进口开启时,慢慢开启排气针形阀. 记录压差.

Drawback of vertical tubular air preheater is the greater corrosion of tubes at the low temperature zone due to cold air inlet.

立式管式空气预热器的缺点，是冷风进口处的管束低温腐蚀严重。

The fresh-air inlet was usually the crankcase breather cap.

新鲜空气进口一般是曲轴箱通气盖.

Fuel supply system, air inlet and thermostat system were modified to accomodate to the characteristics of alcohol combustion.

针对乙醇燃料的特点，改造调整了原汽油机的供油系统、点火系统、进气预热和保温系统；

The fuselage & engine thethe MD 500 D The difference are, self-pressurize fuel takethe air inlet strainer.

机身 和 发动机采用MD500D民用型的设计, 区别在于加装自密封燃油箱、发动机进气道过滤器.

Connect the air inlet hose to the throttle body and the air cleaner.

将空气入口软管接至节流阀体和空气滤清器.